In the case of a Light Strip, for example, this is the small box as you can see in the following picture.Įven if you don’t need a dimmer switch at the moment, it can be very useful to have one of the practical switches as a helper in your drawer. In this case, simply use any dimmer switch and reset the lamp – your Hue Bridge will then find it immediately.įinally, a small tip: The dimmer switch must always be held as close as possible to the ZigBee module of the lamp. In all three cases, your Bridge may not find the lamp immediately.
In these cases, a Hue lamp is not immediately found by the Hue Bridge. The lamp should then start to flash for a few seconds and is then reset. You still hold the dimmer switch close to the desired switched-on lamp and press the top and bottom buttons simultaneously for about 10 seconds. The new switch no longer has two buttons for “On” and “Off”, but a combined On/Off button and a “Hue” button.įortunately, the practical function has not changed, even though the switch has a new design. Look for in Library>Application>Support, then delete that folder as well. In the past few weeks, however, I have repeatedly received questions on this very topic, because the labelling of the buttons on the Philips Hue dimmer switch of the second generation are somewhat different. Look for the HueSync folder and open the Cache folder inside it, then all the contents inside that folder, but don’t remove the original folder itself.
I have often explained how to reset a lamp with the dimmer switch. This is how easy it is to reset a Hue lamp Several buyers had no idea how to reset the lamps so that the new Bridge would find them immediately – although it is so easy with the dimmer switch. In the past few days I have sorted out some old lamps and sold them on eBay.